مشكلة Titanhide على أنظمة x64bit

[Stingered]

32bit is not the answer.

Installation Steps for TitanHide on Windows 7
To install TitanHide on Windows 7, follow these steps:

Copy the Driver File
Place the TitanHide.sys file in the C:\Windows\system32\drivers directory.
Create the Service
Open an administrative command prompt and run the following command to create the TitanHide service:


sc create TitanHide binPath= C:\Windows\system32\drivers\TitanHide.sys type= kernel
Start the Service
Use the command below to start the TitanHide service:


sc start TitanHide
Check the Service Status
To verify that TitanHide is running, execute:


sc query TitanHide
Important Considerations
Test Mode Requirement: TitanHide is an unsigned driver, so you must enable test mode on your Windows 7 system. This can be done by 
running the command:


bcdedit /set testsigning on
After executing this command, restart your computer.
Administrative Privileges: Ensure you have full administrative rights to perform these actions, as they require elevated 
permissions.


If that fails, try https://github.com/Air14/HyperHide